Back to S55 Wiki

S55 Servicing & Maintenance

Please take this advice as general in nature and choose what best works for you and your situation.

Performance Recommended Service Intervals

ItemInterval
Engine Oil10,000 KM or 5,000 KM if using Ethanol Fuels regularly
Transmission (DCT) Oil50,000 KM
Transmission (Manual) Oil50,000 KM
Differential Fluid50,000 KM
Spark PlugsOEM Gap 50,000 KM, 0.022inch Gap 25,000 KM
Coil Packs80,000 KM
Injectors120,000 KM
Coolant85,000 KM
Brake Fluid50,000 KM
Brake Pads30,000 KM or When Indicator Lamp Is Active (Track Use Reduces Life)
Intake Filter50,000 KM
Cabin Filter30,000 KM
Accessories Belt100,000 KM

Preventative Maintenance & Common Failure Points

Crank Hub / Crank Pulley

The S55 crank hub can slip under high loads, especially with tuned power levels or hard launches. This is a critical failure point that can cause significant engine damage. Pin the crank hub or upgrade to a keyed solution.

Valve Cover & Gasket

Like the N55, the S55 valve cover is plastic and can crack. The gasket also deteriorates over time, causing oil leaks. Replace the entire valve cover assembly if cracked.

Oil Filter Housing Gasket

A common source of oil leaks on the S55. The gasket deteriorates over time and should be replaced preventatively around 80,000 KM.

Charge Pipes

While more robust than N55 charge pipes, the stock S55 charge pipes can still fail under high boost. Upgrading to aluminium charge pipes is recommended for tuned applications.

VANOS Solenoids

VANOS solenoids can fail over time causing rough idle and performance issues. Regular oil changes help extend their life.

Water Pump & Thermostat

The electric water pump and thermostat are common failure items. Preventative replacement around 100,000 KM is recommended.

Rod Bearings

Some early S55 engines experienced rod bearing wear issues. Monitor for bearing noise and consider inspection at high mileage or with tuned applications.

Carbon Buildup

Direct injection engines are prone to carbon buildup on intake valves. Install a catch can and consider periodic walnut blasting to maintain performance.

Turbo Wastegate Actuators

The electronic wastegate actuators can wear over time. Upgraded actuators are available for improved response and durability.

Recommended Engine Oils

Understanding Oil Weight Classifications

Multi-grade oils are rated with two numbers separated by a W (e.g. 5W-40). The W stands for Winter and refers to the oil's viscosity at cold temperatures.

  • •First number (e.g. 0W, 5W, 10W) — The oil's cold temperature viscosity grade. Lower numbers mean the oil is thinner and flows more easily when cold. A 0W oil has lower viscosity at cold temperatures than a 10W, meaning it circulates faster through the engine on a cold morning.
  • •Second number (e.g. 30, 40, 60) — The oil's viscosity at operating temperature (100°C). Higher numbers mean a thicker oil film at temperature, providing greater protection under load and at higher temperatures.

Example: A 5W-40 has the cold viscosity of a 5-weight oil, allowing it to flow and circulate quickly when cold, while maintaining the thickness of a 40-weight oil at 100°C. A 0W-40 would have even lower cold viscosity but the same oil film thickness at operating temperature.

BMW LL (Long Life) Oil Ratings

  • LL-98: Older gasoline engines (1998)
  • LL-01: High temp stability for gasoline (2001)
  • LL-04: Gasoline & diesel with DPF (2004)
  • LL-01 FE: Fuel economy variant of LL-01, uses lower viscosity for reduced friction
  • LL-12/14/17 FE+: Fuel economy focused for newer engines

S55 engines are compatible with LL-01 rated oils.

The oil weights below may not be 100% what you need if you have had an engine rebuild. Refer to your engine builder on what oil weight you should run based on your bearing clearances.

For Extreme Racing Applications

WeightBrandRating
10W-60Shell Helix Ultra RacingA3/B4, BMW M Approved
10W-60Castrol EDGE SupercarA3/B4, BMW M Approved
10W-60BMW M TwinPower TurboA3/B4, LL-01
10W-40Motul 300V CompetitionA3/B4, Ester Core
15W-50Red Line Racing OilA3/B4
10W-40Penrite 10 Tenths Racing 10A3/B4, LL-98

For Most Climates

WeightBrandRating
5W-40Castrol EDGEA3/B4, LL-01
5W-40LIQUI MOLY Pro-Engine M900A3/B4, LL-01
5W-40Mobil Super Synthetic Formula BA3/B4, LL-01
5W-40MOTUL 8100 X-CESS GEN2A3/B4, LL-01
5W-40Pennzoil Platinum EuroA3/B4, LL-01
5W-40Shell Helix UltraA3/B4, LL-01
5W-40Penrite HPR 5A3/B4, LL-01

For Very Cold Climates

WeightBrandRating
0W-40Castrol EdgeA3/B4, LL-01
0W-40Mobil 1 FSA3/B4, LL-01
Common ModificationsEngine Specifications